FTTX Demo Tutorial

Start here

Words & colours

OLT, ONU, PON, Rx / Tx power, LOS, dying gasp and what each colour means, in plain language.

For everyone
On this page

The network, from POP to customer #

Light travels from your POP to the customer through these parts. The app uses the same words everywhere.

POP Your site with the active equipment
OLT Sends light into the fiber
PON port One fiber leaving the OLT
Splitter Divides one fiber into 2–64
ONU Box at the customer
Customer Router behind the ONU
WordMeaning
OLTOptical Line Terminal. The central device in a POP. One OLT serves hundreds or thousands of ONUs.
PON portOne optical port of the OLT. Everything on that fiber (splitters, ONUs) shares it. Written like GPON 0/1/3.
GPON / EPONTwo technologies for the same job. An OLT is one or the other; the app detects it.
ONU (ONT)The box at the customer's end of the fiber. Identified by its serial number (GPON) or MAC (EPON).
Router MACThe address of the customer's router seen behind the ONU. It is how a customer account is matched to an ONU.
Shared ONUAn ONU with more than one router behind it (several customers on one ONU).
POPPoint of presence: a site that houses routers, switches and OLTs.
TJ boxA joint enclosure outside, where fibers are spliced and splitters sit.
SplitterA passive part that divides the light. A 1:8 splitter feeds 8 outputs and costs about 10.5 dB.
CoreOne glass fiber inside a cable. Cores have standard colours (blue, orange, green…).
SyncThe app asking an OLT for fresh data. Happens automatically on a schedule, or when you press Sync now.
DCMThe billing system. Customers can be pulled from it automatically.

Optical power (the signal) #

Signal strength is measured in dBm. The numbers are negative: closer to zero is stronger. −18 is a strong signal, −27 is weak.

ReadingWhat it is
↓ ONU RxLight the ONU receives from the OLT. The most important number: it tells how good the customer's line is.
↑ ONU TxLight the ONU sends. Normally around +2 dBm.
OLT RxHow much of the ONU's light arrives back at the OLT. Not every OLT model reports it; then the place shows “—”.

The colour bands for ONU Rx

Good

−8 to −25 dBm

Healthy. Nothing to do.

Weak

−25 to −28 dBm

Works, but close to the limit. Check before it fails.

Critical

below −28 dBm

Too weak. Expect drops: dirty connector, bent or damaged fiber.

Too strong

above −8 dBm

Overload. Add an attenuator.

Grey / “No reading” means the OLT gave no value: the ONU is offline, or that OLT model does not report it.

ONU status and why it went down #

StatusMeaningUsual cause
OnlineWorking.—
LOSLoss of signal: the OLT sees no light from the ONU.Fiber cut or unplugged. One ONU = its drop cable; most ONUs of a PON port = the feeder cable.
Dying gaspThe ONU said “I am losing power” before going off.Power cut at the customer, or the ONU was switched off.
OfflineDown, with no clear reason reported.Powered off for long, removed, or unknown.

Where the OLT gives more detail, the app shows a last down reason such as “Individual Fiber / Optical Loss”, “PON / Feeder Fiber Down”, “Power Off”, “OLT Reboot” or “Admin Down / Deactivated”.

Temperature and laser bias #

Many OLTs also report the health of the optical modules themselves:

  • ONU temperature (°C): Warm from 65 °C, Hot from 75 °C. A hot ONU sits in a closed box or in the sun and will fail early.
  • PON port laser bias (mA): the current the OLT's laser needs. Elevated from 70 mA, High from 90 mA. A bias that keeps rising means the laser is ageing: plan to replace that module.
  • PON port temperature: Warm from 70 °C, Hot from 80 °C.

Your administrator may have set other limits.

Colours on the map and in lists #

ItemColour
POP dark navy square
TJ box orange
ONU green good · orange weak · red critical or down · grey no reading
Customer pink
Cable blue line; dashed orange = waiting for review

Everywhere in the app: green is good, amber needs watching, red needs action, grey means no data.

Finished this topic?

Tick it off; the topic list shows what you have read.