FTTX Demo Tutorial

Fiber network

Loss standards & expected power

How the app works out the power every splitter and ONU should receive, and the loss values behind it.

Who can use it: Super Admin, NOC Admin, Field Technician, Employee Open this page in the app
On this page

What this is for #

Light gets weaker on its way from the OLT to the customer: every splitter, every kilometre of fiber, every connector and splice takes a little. The app adds these losses up and tells you the power each splitter and ONU should receive. Comparing that with the real reading shows where something is wrong.

Example

PON port launches +4.5 dBm − 1:8 splitter 10.5 − 1:4 splitter 7.3 − 2 km fiber 0.7 − connectors & splices 1.8 = expected −15.8 dBm at the ONU

If the ONU really reads −23 dBm, about 7 dB is being lost somewhere it should not: a dirty connector, a tight bend or a bad splice.

The loss standards page #

Menu Loss standards. These are the default values used in every calculation. Everyone who can see devices can read them; changing them needs the “Edit the optical loss standards” permission.

Optical loss standards
Optical loss standards (example with sample data)
  1. 1 Splitters: the loss of each split ratio, in dB.
  2. 2 Fiber, connectors, splices: loss per kilometre, per device input and per cable segment.
  3. 3 Add a ratio you use that is not listed.
Sample data, not a real network. Tap a number or a line to match them; tap the picture to enlarge.

Where you see expected power #

  • Device page → Optical power budget: a step table (launch power, each loss, power after each step), and the expected output per splitter port.
  • Device form: a live preview while you choose the uplink, before saving.
  • Map panel of an ONU: Expected power and Reading vs expected. ONUs without a reading get a dashed ring in the expected colour.
  • Cable pages: the fiber loss of the cable.

Make the numbers right #

  1. Set the PON launch power on each OLT device (edit the OLT in Devices). You can give one value for all ports or one per port. Without it the page says “Set the PON power on the OLT device”.
  2. Give each splitter its correct ratio. A measured or unbalanced splitter can carry its own loss on its form.
  3. Record the cable and core that feed each splitter. Where no cable is recorded the app uses the straight-line distance and marks the result estimated.

Finished this topic?

Tick it off; the topic list shows what you have read.