Monitoring
OLT page
One OLT in detail: sync status, CPU / memory, PON ports with laser readings and the ONU list.
What this page is for #
Everything about one OLT: is it reachable, when did it last sync, how busy is it, how is each PON port doing, and the list of its ONUs. Open it by tapping an OLT's name anywhere in the app.
- 1 Facts: ownership, model, uptime, last and next sync, location.
- 2 Sync now fetches fresh data from the OLT.
- 3 Test connection checks that the OLT answers and detects its vendor, model and PON type.
- 4 Add ONU registers a new ONU on the OLT (shown on OLT types that support it).
- 5 Place in fiber network puts this OLT into your site / device tree so splitters and ONUs can hang off it.
- 6 Sync result: when it last ran, when the next one is planned, how long it took and what it read. A failure is explained here.
OLT health and ONU summary #
- 1 CPU and memory of the OLT. Amber from 70 % / 80 %, red from 90 %.
- 2 Per core / per board load, where the OLT reports it.
- 3 ONU status: how many are online, offline, in LOS or sent a dying gasp.
- 4 Signal quality of the online ONUs: good, weak, critical.
PON ports #
One card per PON port. The bar shows how many of its ONUs are online.
- 1 A port card: ONUs online / total, the laser bias (mA), temperature and Tx power of the port’s module. Amber or red chips need attention. Tap a card to show only that port’s ONUs below.
- 2 Legend: green ≥ 90 % online, amber 70–90 %, red below 70 %.
The ONU list of this OLT #
- 1 Search by serial, MAC or customer.
- 2 Status chips filter the list; “Show” sets how many rows.
- 3 Serial number opens the ONU’s own page. Under it: router MAC(s), description, model.
- 4 Refresh reads this one ONU live from the OLT (a few seconds).
- 5 Place on map adds this ONU to the fiber network at a position.
The power column reads ↓ ONU Rx / ↑ ONU Tx · OLT Rx with the ONU temperature beside it. See what the numbers mean.
Common tasks #
Sync this OLT and follow the progress
Needs: NOC Admin
- Press Sync now.
- A box appears under the header: the place in the queue, then the step the sync is on.
- If something more urgent waits, press Run next there; Stop ends a running sync.
If you press Sync now while one is already waiting, the page tells you where it is in the queue.
The sync failed: check the connection
Needs: NOC Admin
- Read the message in the SNMP sync card.
- Press Test connection. It tells you whether the OLT answers.
- No answer: press Edit and check the IP, SNMP port and community; check that the OLT is reachable from the server.
See only the ONUs of one PON port
- Scroll to PON ports and tap the port's card.
- The ONU list below now shows only that port. Tap the card again to clear.
Put the OLT into the fiber network
Needs: NOC Admin
- Press Place in fiber network.
- The device form opens with this OLT chosen. Pick its site (POP) and the switch port it is connected to, then save.
After that the OLT appears in Topology and splitters can be connected to its PON ports.
The yellow bar says “no ownership set”
Press Set it, choose Owned or Reseller on the form and save.
Related topics
Finished this topic?
Tick it off; the topic list shows what you have read.